The short version of LC-MS fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-02-25 and is reviewed periodically as new material appears.
Early published reports described melanotan-2 as a tanning agent without sun protection, which means darkening is not the same as protection against ultraviolet radiation. Later studies explored the peptide in erectile dysfunction, hemorrhagic shock, and some skin conditions. No regulator in the United States or Europe has approved it for clinical use. Many products labelled melanotan-2 are sold without approval and their identity and purity are unverified. Its long-term safety in humans remains an open question.
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
| Property | Value | Notes |
|---|---|---|
| Compound class | Synthetic cyclic heptapeptide | Alpha-MSH analogue containing a D-phenylalanine residue |
| Molecular formula | C50H69N15O9 | Average molecular mass approximately 1024.2 g/mol |
| Appearance | White to off-white lyophilised powder | Normally supplied as a freeze-dried solid in a sealed vial |
| Solubility | Freely soluble in water and polar solvents | Dissolves readily in aqueous buffers and in alcohol-water mixtures |
| Receptor targets | MC1R, MC3R, MC4R, MC5R | Acts as a non-selective melanocortin receptor agonist |
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Lyophilised peptide powder is comparatively stable when kept dry, cold and protected from light. Once dissolved, the molecule is exposed to hydrolysis, oxidation and microbial growth, and degradation accelerates at higher temperatures and in alkaline solution. Repeated freeze-thaw cycles concentrate solutes and promote aggregation. Handling guidance for research peptides commonly clusters around freezer temperatures for powder and short refrigerated use for reconstituted solutions, with pH control and sterile technique applied throughout.
Verification of a purchased sample requires documentation linking a batch to a certificate of analysis, and that document should be read for the methods used rather than the headline purity figure. A single chromatographic percentage does not establish identity. Independent laboratories can perform identity and content assays, but no such test establishes that a product is suitable for human use. Claims about efficacy rest largely on small, early studies rather than on replicated controlled trials, and that gap remains open.
Melanotan-2 is a synthetic linear peptide built from seven amino acids arranged in a short chain. Its sequence is commonly written as Ac-Nle-Asp-His-D-Phe-Arg-Trp-Lys-NH2, which includes a modified N-terminus and an amidated C-terminus. The molecule belongs to the melanocortin family and acts as a receptor agonist. Structural features such as the D-phenylalanine residue and the Nle substitution are associated with increased stability against enzymatic degradation relative to the natural parent peptide.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Analytical confirmation of identity relies on mass spectrometry, most often coupled to liquid chromatography. Reversed-phase high-performance liquid chromatography separates the peptide from related impurities and provides a purity estimate based on peak area. Electrospray ionization mass spectrometry then confirms the expected molecular mass, while tandem mass spectrometry can map the fragment sequence. For research-grade material, these two techniques together form the standard minimum. Purity figures reported by vendors are frequently not traceable to an independent laboratory.
Independent verification is central to quality control because the compound is not produced under pharmaceutical manufacturing standards. Third-party laboratories can measure purity, identity, residual solvents, and microbial contamination, though the scope of testing varies between services. Reported analyses of vendor samples have shown batch-to-batch variation in peptide content and the presence of truncated or oxidized species. How much of this variation reflects synthesis conditions versus storage and shipping is not well characterized. No harmonized reference standard exists for the material as sold.
Handling guidance for melanotan II follows general practice for small synthetic peptides rather than a product-specific monograph. Lyophilized powder is typically kept at minus twenty degrees Celsius or colder, protected from light and moisture, because warmth and humidity accelerate degradation. Once reconstituted, solutions are usually refrigerated and used within a short window, as hydrolysis and microbial growth both become concerns. Repeated freeze-thaw cycles are generally avoided. These conventions come from laboratory peptide chemistry and not from formal stability studies on this specific compound.
== Side effects == Side effects of prazepam are less profound than with other benzodiazepines. Excessive drowsiness and with longer-term use, drug dependence, are the most common side effects of prazepam. Side effects such as fatigue or "feeling spacey" can also occur but less commonly than with other benzodiazepines. Other side effects include feebleness, clumsiness or lethargy, clouded thinking and mental slowness.
== External links == Drug Interactions: What You Should Know. U.S. Food and Drug Administration, Center for Drug Evaluation and Research, September 2013 COVID 19 Drug interaction check tool University of Liverpool
=== Blood pressure control === Blood pressure control may be indicated after a TIA to reduce the risk of ischemic stroke. About 70% of patients with recent ischemic stroke are found to have hypertension, defined as systolic blood pressure (SBP) > 140 mmHg or diastolic blood pressure (DBP) > 90 mmHg. Until the first half of the 2010s, blood pressure goals have generally been SBP < 140 mmHg and DBP < 90 mmHg. However, newer studies suggest that a goal of SBP <130 mmHg may confer even greater benefit. Blood pressure control is often achieved using diuretics or a combination of diuretics and angiotensin converter enzyme inhibitors, although the optimal treatment regimen depends on the individual. Studies that evaluated the application of blood pressure‐lowering drugs in people who had a TIA or stroke concluded that this type of medication helps to reduce the possibility of a recurrent stroke, a major vascular event, and dementia. The effects achieved in stroke recurrence were mainly obtained through the ingestion of angiotensin-converting enzyme (ACE) inhibitor or a diuretic.
== Mobile phases == A mobile phase in RP-LC consists of mixtures of water or aqueous buffers, to which further solvents are added, to elute analytes from a reversed-phase column in a selective manner. The added solvents must be miscible with water. These are also called "modifiers", since they modify the polarity of the mobile phase. Water is the most polar solvent in the reversed phase mobile phase. To increase the elution strength of the mobile phase, one usually add modifiers to lower its polarity. Common modifiers include acetonitrile (ACN), methanol (MeOH), 2-propanol (isopropanol, IPA), ethanol (EtOH) and tetrahydrofuran (THF).
Sources: en.wikipedia.org
== Protein synthesis == Protein anabolism is the process by which proteins are formed from amino acids. It relies on five processes: amino acid synthesis, transcription, translation, post translational modifications, and protein folding. Proteins are made from amino acids. In humans, some amino acids can be synthesized using already existing intermediates. These amino acids are known as non-essential amino acids. Essential amino acids require intermediates not present in the human body. These intermediates must be ingested, mostly from eating other organisms.
==== France ==== In France, most preparations containing codeine only began requiring a doctor's prescription in 2017. Products containing codeine include Néocodion (codeine and camphor), Tussipax (ethylmorphine and codeine), Paderyl (codeine alone), Codoliprane (codeine with paracetamol), Prontalgine and Migralgine (codeine, paracetamol and caffeine). The 2017 law change made a prescription mandatory for all codeine products, along with those containing ethylmorphine and dextromethorphan.
An opioidergic agent (or drug) is a chemical which directly or indirectly modulate the function of opioid receptors. Opioidergics comprise opioids, as well as allosteric modulators and enzyme affecting agents like enkephalinase inhibitors.
immune response; wound healing; muscle strength (including respiratory muscles); renal capacity and depletion leading to water and electrolyte disturbances; thermoregulation; and menstruation. Malnutrition can lead to vitamin and other deficiencies and to inactivity, which in turn may pre-dispose to other problems, such as pressure sores. Unintentional weight loss can be the characteristic leading to diagnosis of diseases such as cancer and type 1 diabetes. In the UK, up to 5% of the general population is underweight, but more than 10% of those with lung or gastrointestinal diseases and who have recently had surgery. According to data in the UK using the Malnutrition Universal Screening Tool ('MUST'), which incorporates unintentional weight loss, more than 10% of the population over the age of 65 is at risk of malnutrition. A high proportion (10–60%) of hospital patients are also at risk, along with a similar proportion in care homes.
=== Interaction with lipid membranes === Experimental evidence has been collected on the interaction of alpha-synuclein with membrane and its involvement with membrane composition and turnover. Yeast genome screening has found that several genes that deal with lipid metabolism and mitochondrial fusion play a role in alpha-synuclein toxicity. Conversely, alpha-synuclein expression levels can affect the viscosity and the relative amount of fatty acids in the lipid bilayer. Alpha-synuclein is known to directly bind to lipid membranes, associating with the negatively charged surfaces of phospholipids. Alpha-synuclein forms an extended helical structure on small unilamellar vesicles. A preferential binding to small vesicles has been found. The binding of alpha-synuclein to lipid membranes has complex effects on the latter, altering the bilayer structure and leading to the formation of small vesicles. Alpha-synuclein has been shown to bend membranes of negatively charged phospholipid vesicles and form tubules from large lipid vesicles. Using cryo-EM it was shown that these are micellar tubes of ~5-6 nm diameter. Alpha-synuclein has also been shown to form lipid disc-like particles similar to apolipoproteins. EPR studies have shown that the structure of alpha synuclein is dependent on the binding surface. The protein adopts a broken-helical conformation on lipoprotein particles while it forms an extended helical structure on lipid vesicles and membrane tubes. Studies have also suggested a possible antioxidant activity of alpha-synuclein in the membrane.
Sources: en.wikipedia.org
No. It is a laboratory-made peptide, while the natural hormone is alpha-melanocyte-stimulating hormone, a longer peptide produced by the pituitary gland and by skin cells. Melanotan-2 mimics only a short active region of that hormone and contains non-natural residues such as D-phenylalanine.
No approved regulatory indication exists in major markets. An approval exists for a different peptide, afamelanotide, which is used for a rare photosensitivity disorder called erythropoietic protoporphyria. Melanotan-2 itself remains a research compound with no cleared clinical role.
Melanocortin-1 receptors on melanocytes are the receptor most closely linked to pigment production. The peptide is not selective, however, and also activates melanocortin-3, melanocortin-4, and melanocortin-5 receptors. That lack of selectivity is the usual explanation offered for both its range of observed effects and its off-target effects.
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.